American Motors (1970-73)

After wheel brake units have been disassembled for any reason, an initial adjustment MUST be made before drum installation. Use Brake Shoe to Drum Clearance Tool (J-21 177) to pre-set brake shoe adjustment. Install adjuster screw assembly and place small hooked end of adjuster spring in large hole in primary shoe. Place large hooked end of adjuster spring in adjuster lever. Place hooked end of adjuster cable in adjuster lever and position adjuster cable over cable guide. Grasp adjuster lever with pliers and hook adjuster lever tang in large hole in bottom of secondary shoe. Drive car cautiously in reverse, making 10 to 15 "hard" brake applications before road testing. Make sure pedal height is correct. To adjust brakes without removing drums. See " American Motors (1965-69)  "  .