LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2778 (Information Center - Instrumentation, Message Center And Warning Chimes -- F250-F550 Super Duty) >> General Procedures >> Compass Calibration

Compass Calibration

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential electrical accessories (heated rear window, heater, A/C, map lamps, wiper, etc.) and make sure all the doors are closed.

    Start the vehicle.

  2. Press the message center SETUP button until RESET FOR CALIBRATION is displayed.
  3. NOTE: The message center displays CIRCLE SLOWLY TO CALIBRATE in the calibration function.

    Press the RESET control button to start the compass calibration function.

  4. NOTE: This step may require up to 5 circles to complete the calibration.
NOTE: If the RESET button is pressed during the calibration or 3 minutes has elapsed since the beginning of the calibration without driving the vehicle, the message center reverts back to normal operation and the INFO displays CAL until a successful calibration is carried out.

Slowly drive the vehicle in a circle at no more than 5 km/h (3 mph) until the CIRCLE SLOWLY TO CALIBRATE display changes to CALIBRATION COMPLETED.