LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2769 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs >> Installation

Wheel Studs: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position a new wheel stud, aligning the serrations in the wheel hub made by the original stud.
    2. NOTE: Make sure to use washers that have an ID that is larger than the OD of the wheel stud serrations. Use enough washers (approximately 4) to allow the wheel stud to fully seat against the hub flange.
    Fig 1: Locating Washers Over Outside End Of Wheel Stud
    G06776382Courtesy of FORD MOTOR CO.
  2. Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.
  3. Remove the wheel nut and washers.
    4. NOTE: Be sure to align index marks made during the removal step.
  4. Install the brake disc.
  5. Position the brake caliper and anchor plate assembly and install the 2 anchor plate bolts.
    • F-250 and F-350, tighten to 225 Nm (166 lb-ft).
    • F-450 and F-550, tighten to 400 Nm (295 lb-ft).
scientia non olet · About LEMON Manuals