Ball Joint: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: To avoid damage to components, do not use heat to aid installation.

NOTE: Clean the wheel knuckle ball joint bores.

NOTE: The upper ball joint must be installed first.

Fig 1: Installing Upper Ball Joint

Courtesy of FORD MOTOR CO.

Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, install the upper ball joint.
Using the C-Frame and Screw Installer/Remover and Ball Joint Installer/Remover, install the lower ball joint.

Fig 2: Installing Lower Ball Joint
Courtesy of FORD MOTOR CO.
Install the snap ring in the groove at the bottom of the lower ball joint.
Install the lower ball joint grease plug.
Install the front wheel spindle or wheel knuckle assembly. For additional information, refer to WHEEL SPINDLE - F-250, F-350 or WHEEL KNUCKLE - F-450, F-550 .