General Specifications
WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Transmission Fluid | |
|
NOTE:
Use only transmission fluid that is recommended for this transmission, the use of any other transmission fluid may result in transmission failure.
NOTE:
Approximate dry capacity includes transmission fluid cooler and transmission fluid cooler tubes. Transmission fluid level procedures in this service information should be used to determine actual transmission fluid requirements and transmission fluid specification. DO NOT OVERFILL. If it is necessary to add or change transmission fluid, use only transmission fluid that is recommended for this transmission. |
|
| Component Mounting Temperatures | |
| Taper roller bearing inner race | 150°C (302°F) |
| Synchronizer assemblies | 150°C (302°F) |
| Thrust washers | 150°C (302°F) |
| Shaft bushings | 150°C (302°F) |
| Top roller bearing outer race | 150°C (302°F) |
| Output ball bearing | 150°C (302°F) |
| Physical Weight | |
| Transmission (with fluid) | 113 kg (250 lb) |
| Preload | |
| Mainshaft and countershaft | 0.02-0.09 mm (0.0007-0.003 in) |
| Synchronizer | |
| 1st and 2nd service limit | 1.0 mm (0.39 in) |
| 1st and 2nd synchronizer with new gear and synchronizer ring clearance | 1.5-1.85 mm (0.059-0.072 in) |
| 3rd, 4th, 5th, reverse and low service limit | 1.0 mm (0.39 in) |
| 3rd, 4th, 5th, reverse and low with new gear and synchronizer ring clearance | 1.4-1.7 mm (0.055-0.066 in) |