LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2751 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Turbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor >> Removal

Turbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor: Removal

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Turbine Shaft Speed (TSS) and intermediate shaft speed sensor connector.
    Fig 1: Locating Intermediate Shaft And Turbine Shaft Combination Speed Sensor Electrical Connector
    G06140638Courtesy of FORD MOTOR CO.
    2. NOTE: Prior to removing the sensor, make sure that the area around the sensor is free of foreign material to prevent contamination entering the transmission.
  2. Remove the TSS  and intermediate shaft speed sensor.
    1. Remove the bolt.
    2. Remove the TSS  and intermediate shaft speed sensor.
      Fig 2: Identifying TSS And Intermediate Shaft Speed Sensor
      G06140639Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals