LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2751 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Solenoid Body Assembly >> Installation

Solenoid Body Assembly: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new solenoid body gasket.
    Fig 1: Locating Main Control Body Gasket
    G06140626Courtesy of FORD MOTOR CO.
  2. Using the Valve Body Aligner, install the solenoid body and loosely install the bolts.
    • While installing the solenoid body, align the manual valve.
      Fig 2: Locating Solenoid Body And Bolts
      G06140628Courtesy of FORD MOTOR CO.
  3. Tighten all the bolts in the sequence shown in the illustration.
    • Tighten to 13 Nm (115 lb-in).
      Fig 3: Identifying Solenoid Body And Bolts Tightening Sequence
      G06599483Courtesy of FORD MOTOR CO.
  4. Connect the TR  sensor connector.
    Fig 4: Locating Transmission Range Sensor Connector
    G06140630Courtesy of FORD MOTOR CO.
  5. Install the transmission fluid filter, pan gasket and pan. For additional information, refer to FLUID PAN, GASKET AND FILTER .
  6. Connect the transmission vehicle harness connector.
    • Tighten to 5 Nm (44 lb-in).
      Fig 5: Locating Transmission Vehicle Harness Connector
      G06140624Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals