LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2751 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F250-F550 Super Duty) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> External Leaks

External Leaks

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC ROUTINES - EXTERNAL LEAKS

Possible Component Reference/Action
255 - ROUTINE 
Powertrain Control System   
  • Turbine Shaft Speed (TSS)/intermediate shaft speed sensor, Output Shaft Speed (OSS) sensor, transmission vehicle harness connector
  • Inspect for leakage. If areas around sensor or transmission vehicle harness connector show signs of leakage, install a new sensor O-ring seal.
Transmission Fluid   
  • Incorrect level
  • Condition
Transmission External Remote Filter   
 
  • Inspect for leakage. If damaged, repair as necessary.
Incorrect Line Pressures   
  • High/low pressures
  • Check pressure at line tap. Carry out Line Pressure Test. Refer to SPECIAL TESTING PROCEDURES . Follow the pressure diagnosis test as required.
Solenoid Body Assembly   
  • Bolts not tightened to specification
  • Tighten to specification.
  • Filter gasket damaged
  • Inspect for damage. If damaged, install a new filter gasket.
  • Contamination
  • Disassemble and clean.
  • Solenoid(s) damaged, stuck or bore damaged. Manual valve stuck or bore damaged
  • If damaged or parts are missing, install a new solenoid body assembly. If misassembled, reassemble correctly.
Fluid Pump Assembly   
  • Bolts not tightened to specification
  • Tighten to specification.
  • Gasket damaged
  • Inspect for damage. If damaged, install a new gasket.
  • O-ring damaged
  • Inspect for damage. If damaged, install a new O-ring.
  • Porosity
  • Inspect for damage. If damaged, repair as necessary.
Transmission Case Assembly   
  • Case vent damaged, case porosity
  • Inspect for damage. If damaged, repair as necessary.
Seals/Gaskets   
  • Leakage at gaskets, seals
  • Refer to LEAKAGE INSPECTION . Remove all traces of lubricant on exposed surface of the transmission. Repair as necessary.