LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2748 (Engine Mechanical - 6.8L (3V) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Exhaust Manifold - LH >> Installation

Exhaust Manifold - LH: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install 10 new exhaust manifold-to-cylinder head studs.
    • Tighten to 12 Nm (106 lb-in).
  2. Using new exhaust manifold gaskets, position the gaskets and the exhaust manifold and install 10 new exhaust manifold nuts.
    • Tighten to 25 Nm (18 lb-ft) in the sequence shown in illustration.
      Fig 1: LH Exhaust Manifold Nuts Tightening Sequence
      G06773471Courtesy of FORD MOTOR CO.
  3. Position the exhaust manifold heat shield and install the 3 bolts.
    • To install, tighten to 14 Nm (124 lb-in).
  4. Install the 4 exhaust Y-pipe flange nuts.
    • Tighten to 40 Nm (30 lb-ft).
scientia non olet · About LEMON Manuals