LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2748 (Engine Mechanical - 6.8L (3V) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate the crankshaft rear seal with clean engine oil prior to installation.
    Fig 1: Installing Crankshaft Rear Oil Seal
    G06126455Courtesy of FORD MOTOR CO.
  1. Using the Crankshaft Rear Oil Seal Installers, install a new crankshaft rear seal.
    2. NOTE: Lubricate the crankshaft oil slinger with clean engine oil prior to installation.
    Fig 2: Installing Crankshaft Rear Oil Slinger Using Special Tools
    G06126456Courtesy of FORD MOTOR CO.
  2. Using the Crankshaft Rear Oil Seal Installers and the Crankshaft Rear Oil Slinger Installer, install a new crankshaft oil slinger.
  3. Install the engine rear cover plate.
  4. Install the flexplate or flywheel. For additional information, refer to FLEXPLATE  or FLYWHEEL .
scientia non olet · About LEMON Manuals