LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2748 (Engine Mechanical - 6.8L (3V) -- F250-F550 Super Duty) >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Assembly

Cylinder Head: Assembly

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the camshaft and camshaft journals with clean engine oil and install the camshaft.
  2. Install the 6 camshaft bearing caps in their original locations.
    • Lubricate the camshaft bearing caps with clean engine oil.
    • Position the front camshaft bearing cap.
    • Position the remaining 5 camshaft bearing caps.
    • Install the 12 bolts finger-tight.
    3. NOTE: Lubricate the valve stem with clean engine oil prior to installation.
  3. Install the valve into the cylinder head.
    4. NOTE: Lubricate the valve seal and valve stem with clean engine oil prior to installation.
  4. Position a new valve seal onto the valve stem.
  5. Using the Valve Stem Oil Seal Installer, install the new valve seal.
    Fig 1: Installing Valve Seal Using Special Tool
    G06126401Courtesy of FORD MOTOR CO.
    6. NOTE: If the components are to be reinstalled, they must be installed into their original locations or engine damage may occur.
    Fig 2: Removing/Installing Valve Spring Retainer Keys
    G06126394Courtesy of FORD MOTOR CO.
  6. Using the Valve Spring Compressor, install the valve spring, the valve spring retainer and the 2 valve spring retainer keys.
  7. Repeat the previous 2 steps for each valve.
  8. Remove the 12 bolts the front camshaft bearing cap and then the remaining bearing caps.
  9. Remove the camshaft.
scientia non olet · About LEMON Manuals