LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2747 (Engine Mechanical - 5.4L (3V) -- F250-F350 Super Duty) >> In-Vehicle Repair >> Flexplate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Ford Pickup and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. For additional information, refer to REMOVAL .
  2. Remove the 8 bolts and the flexplate.
    • To install, tighten to 80 Nm (59 lb-ft) in the sequence shown in illustration.
      Fig 1: Identifying Flexplate Bolt Tightening Sequence
      G06126446Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals