Exhaust Manifold - LH: Installation

WARNING: This page is about a different car, the 2009 Ford Pickup, 2009 Ford F550 Super Duty, 2009 Ford F450 Super Duty, and 2009 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install 10 new exhaust manifold-to-cylinder head studs.
- Tighten to 12 Nm (106 lb-in).
Using new exhaust manifold gaskets, position the gaskets and the exhaust manifold and install 10 new exhaust manifold nuts.
- Tighten to 25 Nm (18 lb-ft) in the sequence shown.

Fig 1: Identifying Tightening Sequence For LH Exhaust Manifold Bolts

Courtesy of FORD MOTOR CO.

Position the exhaust manifold heat shield and install the 3 bolts.
- To install, tighten to 14 Nm (124 lb-in).
Install the 4 exhaust Y-pipe flange nuts.
- Tighten to 40 Nm (30 lb-ft).