Crankshaft Rear Seal With Retainer Plate: Installation
WARNING: This page is about a different car, the 2009 Ford Pickup, 2009 Ford F550 Super Duty, 2009 Ford F450 Super Duty, and 2009 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Clean and inspect the mating surface.
- Apply a 4.06 mm (0.16 in) bead of silicone gasket and sealant around the crankshaft rear seal retainer plate sealing surface.
- Install the crankshaft rear seal retainer plate and the 6 bolts in the sequence shown.
- Tighten to 10 Nm (89 lb-in).
- Using the Crankshaft Rear Oil Seal Installers, install a new crankshaft rear seal.
- Using the Crankshaft Rear Oil Seal Installers and the Crankshaft Rear Oil Slinger Installer, install a new crankshaft oil slinger.
- Install the oil pan. For additional information, refer to Oil Pan .
NOTE:
Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE:
Clean the sealing surfaces with silicone gasket remover and motorcraft metal surface prep. Follow the directions on the packaging.
NOTE:
If the rear crankshaft seal retaining plate is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure may cause future oil leaks.
NOTE:
The silicone must be applied on the groove along the retainer plate.
NOTE:
Lubricate the crankshaft rear seal with clean engine oil prior to installation.
NOTE:
Lubricate the crankshaft oil slinger with clean engine oil prior to installation.