Output Shaft Seal: Installation

WARNING: This page is about a different car, the 2009 Ford Pickup, 2009 Ford F550 Super Duty, 2009 Ford F450 Super Duty, and 2009 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles with four wheel drive (4WD)

Using the special tool, install a new output oil seal.

Fig 1: Installing Output Oil Seal (4X4)

Courtesy of FORD MOTOR CO.

Install the transfer case. For additional information, refer to TRANSFER CASE article.

Vehicles with rear wheel drive (RWD)

Using the special tool, install a new output oil seal.

Fig 2: Installing Output Oil Seal (RWD)

Courtesy of FORD MOTOR CO.

Apply Threadlock 262 to the threads of the transmission flange lock nut. Using the special tools, install the transmission flange.
- Tighten to 330 Nm (244 lb-ft).

Fig 3: Identifying Transmission Flange

Courtesy of FORD MOTOR CO.

All vehicles

Connect the rear driveshaft. For additional information, refer to DRIVESHAFT article.