LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2368 (Manual Transmission - ZF S6-650 & 65-750 - 6-Speed -- F250-F550 Super Duty (2009)) >> In-Vehicle Servicing >> Gearshift Lever And Boot >> Installation

Gearshift Lever And Boot: Installation

WARNING: This page is about a different car, the 2009 Ford Pickup, 2009 Ford F550 Super Duty, 2009 Ford F450 Super Duty, and 2009 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower gearshift lever and gearshift lever blocks into the shift housing.
    • Install the gearshift lever blocks with the notches facing downward.
    2. CAUTION: Do not use a silicone sealing compound.
    NOTE: Do not wait longer than 10 minutes to tighten the bolts due to the rapid cure time of the sealant.
  2. Install the shift housing.
    • Apply Gasket Maker to the sealing surfaces.
    • Tighten to 23 Nm (17 lb-ft).
  3. Install the lower shift lever boot.
    4. Fig 1: Locating Screws & Lower Shift Lever Boot
    GF0049349Courtesy of FORD MOTOR CO.
  4. Apply Threadlock and Sealer to the gearshift lever bolts, and install the upper gearshift lever.
    • Tighten to 35 Nm (26 lb-ft).
    5. Fig 2: Locating Upper Gear Shift Lever Bolt
    GF0049348Courtesy of FORD MOTOR CO.
  5. Install the shift lever boot.
    6. Fig 3: Locating Shift Lever Boot
    GF0049347Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals