Inspection and Verification: Notes
WARNING: This page is about a different car, the 2009 Ford Pickup, 2009 Ford F550 Super Duty, 2009 Ford F450 Super Duty, and 2009 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Road test the vehicle, if possible.
- Get an accurate description of the condition.
- Identify when the condition occurs: when hot or cold, during shifting, driving at a particular speed or in a particular gear.
- Carry out the following Noise Evaluation Procedures, as necessary.
- Visually inspect for obvious signs of wear or mechanical damage
- Get an accurate description of the condition.
- Identify when the condition occurs; when hot or cold, during shifting, driving at a particular speed or in a particular gear.
- Have the customer demonstrate the concern, if possible.
- Carry out the Noise Evaluation Procedures, as necessary.
VISUAL INSPECTION CHARTMechanical - Clutch disc
- Clutch pressure plate
- Clutch hydraulic system
- Clutch pedal
- Pilot bearing
- Clutch release bearing
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, verify the symptom and Go to the following symptom charts. Go to Symptom Chart - Clutch Operation , Go to Symptom Chart - Transmission Operation or Go to Symptom Chart - Noise, Vibration and Harshness (NVH) for additional source information and suggested test procedures.