LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2100 (Engine - 5.4L (3V) -- F-250 & F350 Super Duty) >> In-Vehicle Servicing >> Oil Cooler >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford Pickup and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Drain the engine cooling system. For additional information, refer to ENGINE COOLING article.
  3. Remove and discard the oil filter.
    • To install, tighten to 16 Nm (12 lb-ft).
  4. Disconnect the oil cooler coolant hoses and position aside.
    5. CAUTION: If metal foreign material is present in the oil cooler, mechanical concerns exist. To diagnose mechanical concerns, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
  5. Remove and inspect the engine oil cooler.
    • To install, tighten to 58 Nm (43 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals