LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2100 (Engine - 5.4L (3V) -- F-250 & F350 Super Duty) >> In-Vehicle Servicing >> Flexplate >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford Pickup and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION - TORQSHIFT article.
  2. Remove the 8 bolts and the flexplate.
    • To install, tighten to 80 N.m (59 lb-ft) in the sequence shown.
    3. Fig 1: Identifying Tightening Sequence For Flexplate Or Flywheel Bolts
    G03920141Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals