Exhaust Manifold - RH: Installation

WARNING: This page is about a different car, the 2008 Ford Pickup and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install 8 new exhaust manifold-to-cylinder head studs.
- Tighten to 12 Nm (106 lb-in).
Using new exhaust manifold gaskets, position the gaskets and the exhaust manifold and install 8 new exhaust manifold nuts.
- Tighten to 25 Nm (18 lb-ft) in the sequence shown in illustration.
  
  Fig 1: Identifying RH Exhaust Manifold Bolts Tighten Sequence
  Courtesy of FORD MOTOR CO.
Install the RH inner fenderwell. For additional information, refer to JACKING AND LIFTING .
Install the RH engine support insulator. For additional information, refer to ENGINE SUPPORT INSULATORS .
Install the 4 exhaust Y-pipe flange nuts.
- Tighten to 40 Nm (30 lb-ft).