Remove/Install Seat Belt Guide - AR91.45-P-0500S
Model 214.1
with code 223 (Electric backrest adjustment and head restraints)
Model 223
with code 223 (Electric backrest adjustment and head restraints)
except code 224 (Individual rear seats)
except code U07 (Seat belt extender in rear passenger compartment)
Shown on left seat belt guide (1)
| Remove | |||
| 1 | Fully grip corresponding seat belt guide (1) by hand, press downward and turn 90° counterclockwise as shown. | Bracket (1.1) of seat belt guide (1) must not be opened if seat belt guide (1) is reused. Otherwise, seat belt guide (1) must be replaced, since correct engagement (arrows A) cannot be guaranteed. |
|
| 2 | Pull seat belt guide (1) upward out of seat backrest (2). | ||
| 3 | Release engagement (arrows A) by pulling bracket (1.1) upward, open bracket (1.1) and guide out seat belt. | If seat belt guide (1) is replaced. | |
| Install | |||
| 4 | Place seat belt into new seat belt guide (1) and insert bracket (1.1) in direction of arrow B until it engages. | If seat belt guide (1) has been replaced. | |
| 5 | Close bracket (1.1) on inside and press in catch (1.2). | If seat belt guide (1) has been replaced. |
|
| 6 | Insert seat belt guide (1) into seat backrest in same position as it was pulled out. | ||
| 7 | Turn seat belt guide (1) 90° clockwise. |