Remove/Install Right Heat Shield On Right Turbocharger - AR09.40-P-6027-00SC
Engine 176 in model 223
TURBOCHARGER
| Number | Designation | Engine 176 | |
|---|---|---|---|
| BA09.40-P-1007-01ZA | Bolt, side heat shield to cylinder head cover | Nm | 9 |
ENGINE WIRING HARNESS
| Number | Designation | Engine 176 | |
|---|---|---|---|
| BA15.18-P-1001-01G | Bolt, engine wiring harness to cylinder head cover | Nm | 9 |
INERTING
| Number | Designation | Model 223 | ||||
|---|---|---|---|---|---|---|
| BA86.10-P-1002-03G | Pipe for inerting to engine | M6 | Screw | Nm | 8 | |
| Nut | Stage 1 | Nm | 8 | |||
| Stage 2 | ∠° | - | ||||
- Remove inerting (2) from cable duct (1) and place to one side.
- Unclip retaining clip (6) from heat shield (7) using
disassembly tool.
- Remove bolt (3)
.
- Unscrew screw (4).
- Unclip bracket (5) from right rear engine lifting lug.
- Unclip cable duct (1) from cylinder head cover using
- Remove screws/bolts (8)
- Place piping for inerting (10) to one side.
- Unscrew screw/bolts (9)
- Remove heat shield (7) in upward direction.
- Check elastomer bearings of heat shield (7) for damage.
If damage is present,
↓
replace elastomer bearing.
- Install in the reverse order.