Remove/Install Charge Air Pressure And Temperature Sensor Downstream Of Throttle Valve - AR09.41-P-2012SB
Engine 256 in model 223
Fig 1: Charge Air Pressure And Temperature Sensor Downstream Of Throttle Valve Components Location - Engine 256.9 In Model 223
Shown on engine 256.9
| Notice | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove air filter housing. | AR09.10-P-1150SB | |
| 2 | Release electrical connector (1) and disconnect. | ||
| 3 | Remove screw (2). | *BA09.41-P-1012-01MRT | |
| 4 | Remove charge air pressure/temperature sensor (B159/2). | Lubricant, rubber assembly 1 L |
*BR00.45-Z-1010-06A |
| Fig 2 | |||
| Fig 3 | |||
| 5 | Install in the reverse order. | ||
| Concluding tasks | |||
| 6 | Connect diagnostic system, read out fault memory and clear if necessary. | ||
| AD00.00-P-2000-06FR | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 7 | Perform engine test run. While doing so, check engine for proper operation and leak tightness. |
CHARGE AIR PIPE/CHARGE AIR COOLING
| Number | Designation | Engine 256 | |
|---|---|---|---|
| BA09.41-P-1012-01MRT | Bolt, pressure sensor to charge air distributor | Nm | 6 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1010-06A | Lubricant, rubber assembly 1 L | A 000 989 03 67 |