LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> S580 >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Electrical System, Equipment & Instruments (1 Of 3) -- 223 Chassis >> Basic Knowledge >> Lower Control Panel, Basic Function - GF54.21-P-9800A

Lower Control Panel, Basic Function - GF54.21-P-9800A

Model All (4xWD) 

Example illustration of lower control panel 

G15490229Courtesy of MERCEDES-BENZ USA
1 24 V trailer turn signal indicator lamp
2 24 V charge indicator lamp
3 On-board electrical system voltage/operating hours counter display
4 ESP® OFF push-button switch
5 12 V trailer turn signal indicator lamp
6 On-board electrical system voltage/operating hours counter switchover push-button switch
7 Differential lock push-button switch for front axle with indicator lamps for "Preselected"/"Engaged"
8 Differential lock push-button switch for transfer case with indicator lamps for "Preselected"/"Engaged"
9 Differential lock push-button switch for rear axle with indicator lamps for "Preselected"/"Engaged"
10 "High Range" push-button switch with function indicator lamp
11 "Low Range" push-button switch with function indicator lamp
12 Manual drive program mode push-button switch with function indicator lamp
13 "Dimming" push-button switch, lower control panel
14 Left seat heating push-button switch with function indicator lamp (stage 1/2)
15 Rear window heater push-button switch with function indicator lamp
16 Stationary heater push-button switch with function indicator lamp
17 Right seat heating push-button switch with function indicator lamp (stage 1/2)

Overview 

This document contains information on:

General 

The lower control panel is used to operate driving functions and comfort heaters and to display control and status feedback.

Function 

The lower control panel is connected to the user interface gateway via LIN, which forms the interface to the network architecture of the vehicle.

The lower control panel sends user entries to the user interface gateway; the gateway then forwards these entries to the corresponding systems.

The user interface gateway sends the status information from the corresponding systems for actuating the respective LEDs to the lower control panel.

The lower control panel evaluates the following user entries:

The lower control panel displays the following information: