Remove/Install Rear Axle Level Sensor - AR82.10-P-0005SG

Model 223 

with code Z07 (B7 armoring on special protection version) 

Fig 1: Rear Axle Level Sensor Components Location - Model 223 With Code Z07 (Shown On Left Side)

Courtesy of MERCEDES-BENZ USA

Shown on left side of vehicle 

Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Remove corresponding rear wheel.		AR40.10-P-1102A
2	Disconnect electrical connector (4) from level sensor (B22/7, B22/10).
3	Unclip retaining clip (2).
4	Unscrew ball head of level sensor (B22/7, B22/10) from camber strut (3).
5	Unscrew screw (1) and remove level sensor (B22/7, B22/10).	Do not bend the holder.
		Model 223 (except 223.182) with code Z07 (B7 armoring on special protection version) Screw, Turning angle sensor to Subframe	*BA82.10-P-1003-02I
6	Install in the reverse order.
	Calibrate
7	Calibrate level sensor (B22/7, B22/10) using diagnostic system.	Only when replacing level sensor (B22/7, B22/10).
			AD00.00-P-2000-06FR
	Check
8	Check and correct headlamp adjustment.	Only when replacing level sensor (B22/7, B22/10).
			AP82.10-P-8260LA