Remove/Install Rear Axle Level Sensor - AR82.10-P-0005S

Model 223

except code Z07 (B7 armoring on special protection version)

Fig 1: Rear Axle Level Sensor Components Location - Model 223 Except Code Z07 (Shown On Right Side)

G16192255

Courtesy of MERCEDES-BENZ USA

Shown on right side of vehicle

Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Remove corresponding rear wheel.		AR40.10-P-1102A
2	Disconnect electrical connector from level sensor (B22/7, B22/10).
3	Unclip link rod (1) from link rod (2).	Do not twist level sensor (B22/7, B22/10).
4	Remove screws (3) and remove level sensor (B22/7, B22/10).	Do not bend the holder.
		Screw, level sensor to bracket	*BA82.10-P-1001-02I
5	Remove torsion bar linkage (1) from level sensor (B22/7, B22/10).	Only when replacing level sensor (B22/7, B22/10).
6	Install in the reverse order.
	Calibrate
7	Calibrate level sensor (B22/7, B22/10) using diagnostic system.	Only when replacing level sensor (B22/7, B22/10).
			AD00.00-P-2000-06FR
	Check
8	Check and correct headlamp adjustment.	Only when replacing level sensor (B22/7, B22/10).
			AP82.10-P-8260LA

REAR AXLE LEVEL SENSOR

Number	Designation		Model 223 (except 223.182) except code Z07	Model 223.182
BA82.10-P-1001-02I	Screw, level sensor to bracket	Nm	5	5