Rear Floor Assembly CROSSMEMBER Removal - Ar64.20-P-1145-01S

	000 588 04 39 00 Rivet press tool		WS60.00-P-0440B
	000 588 03 39 00 Rivet die		WS60.00-P-0386K

Model 223.0/1 

Model 223.9 

The following operation steps are shown on model 223.1.

The superordinate service document as well as the safety information in the service document must be observed.

1. Press out self-piercing rivets in crossmember below the rear-end floor (1) with rivet press tool (areas A).

   Courtesy of MERCEDES-BENZ USA

2. Heat up crossmember under the rear-end floor (1) in the cross-hatched areas.

   Cross-hatched areas are bonded with adhesive.

3. Remove crossmember under the rear-end floor (1).

   Courtesy of MERCEDES-BENZ USA

4. Grind mating surfaces down to bare metal in cross-hatched areas.

   Observe pretreatment of bonding surfaces.

5. Remove grinding dust.

   Courtesy of MERCEDES-BENZ USA