Prepare Windshield For Installation - AR67.10-P-1700-04S

Model 206, 254 

Model 214 

Model 223 

except code Z07 (B7 armoring on special protection version) 

Model 232 

Model 236 

Model 294 

Model 295 

Model 296 

Model 297 

Notice	Notes on handling adhesive		AH67.00-P-1000-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A

Only use the adhesive kit specified in the XENTRY Portal parts information.

1. Coat viewing window for the vehicle identification number on the inside of the windshield using primer.

   When replacing windshield, the viewing window is no longer required.

   Do not coat over the adjustment marks for the windshield wipers.

2. Check windshield for damage.

   When reusing windshield.

   If there is a problem:

   ↓

   Replace the windshield.

3. Level remaining adhesive material on windshield to a height of approx. 2 mm using a suitable scraper and remove loose adhesive material.

   When reusing windshield.

4. Repair damaged primer layer on windshield with primer.

   When reusing windshield.

5. Apply cleaner (activator) in bonding area on windshield and rub dry with dry cloth.

   When replacing windshield.

6. Coat bonding area on the windshield with primer.

   When replacing windshield.