Retrofit Wiring Harness For Mercedes-Benz Dashcam At Rear With Existing Mercedes-Benz Dashcam At Front - AZ54.71-P-0003-01SV
Model 223.0/1
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Topical note | Notes on retrofitting electrical/optical lines | AH82.00-P-0000-01A |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1144-02A | Adhesive tape roll, non-woven Tesa tape, 50 meters, 50 mm wide | A 008 989 50 85 09 |
Connection scheme
Routing diagram
On left and right-hand drive vehicles, the branch-off line for the rear dashcam (8.11) of the dashcam wiring harness (8) is routed on the right side.
- Expose black plug (8.1) of rear dashcam branch-off line (8.11).
To do this, remove the fabric tape (41) and pocket (40) from dashcam wiring harness (8).
- Route rear dashcam branch-off line (8.11) in front footwell on right side along longitudinal member and secure with adhesive tape.
Shown with removed seat
- Route rear dashcam branch-off line (8.11) in rear footwell on right side along longitudinal member and secure with adhesive tape.
- Secure rear dashcam branch-off line (8.11) to on-board wiring harness using cable ties.
- Route rear dashcam branch-off line (8.11) on right side along side wall and secure with adhesive tape.
- Secure rear dashcam branch-off line (8.11) to on-board wiring harness using cable ties (arrows).
- Route rear dashcam branch-off line (8.11) from right C-pillar on roof lining to center and secure with adhesive tape.
- Route rear dashcam branch-off line (8.11) by dimension (a) beyond edge (b) of cutout for additional brake lamp in roof lining.
a = 170 mm
-
- Model 223.0##/1## 1#
Strap down extended length of rear dashcam branch-off line (8.11) in front passenger footwell.
- Model 223.0##/1## 2#
Strap down extended length of rear dashcam branch-off line (8.11) in area of right A-pillar.
- Model 223.0##/1## 1#