Remove/Install Front Axle Level Sensors - AR82.10-P-0004S

Model 223 

Fig 1: Front Axle Level Sensors Components Location - Model 223

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Remove corresponding front wheel.		AR40.10-P-1102A
2	Disconnect electrical connector from level sensor (B22/8, B22/9).
3	Unclip torsion bar linkage (1) from level sensor (B22/8, B22/9)./	Do not twist level sensor (B22/8 B22/9).
		Pay attention to installation position.
4	Remove screws (2) and remove level sensor (B22/8, B22/9).	Do not bend the holder.
		Screw, level sensor to bracket	*BA82.10-P-1001-01F
5	Install in the reverse order.
	Calibrate
6	Calibrate level sensor (B22/8, B22/9) using vehicle diagnosis system.	When replacing level sensor (B22/8, B22/9).
			AD00.00-P-2000-06FR
	Check
7	Check and correct headlamp adjustment.	When replacing level sensor (B22/8, B22/9).
			AP82.10-P-8260LA

FRONT AXLE LEVEL SENSOR

Number	Designation		Model 223
BA82.10-P-1001-01F	Screw, level sensor to bracket	Nm	5