Remove/Install Fan For Lamp Unit - AR82.10-P-4742S
Model 223
| Notice | Note on damage to lamp unit | AH82.10-P-0002-00LW | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove | |||
| 1 | Remove appropriate front lamp unit (E1, E2) and place onto a suitable mat. | AR82.10-P-4733S | |
| Risk of injury caused by burns to skin and eyes, risk of poisoning caused by inhaling vapors when working with plastics | Wear protective gloves and safety glasses. Ensure that the work area is adequately ventilated. | AS00.00-Z-0001-02A | |
| 2.1 | Cut housing of front lamp unit (E1, E2) along corresponding embossing (1, 2, 3, 4) using hot knife. | If corresponding cover (5, 6, 7, 8) is not installed. | |
| 000 588 14 84 00 Hot knife | Otherwise, the front lamp unit (E1, E2) will be damaged. Otherwise electric lines will get damaged. |
WS82.00-P-0048B | |
| 2.2 | Remove corresponding cover (5, 6, 7, 8). | If cover (5, 6, 7, 8) is installed. | |
| 3 | Release and disconnect electrical connector from fan. | ||
| 4 | Remove fan from front lamp unit (E1, E2). | ||
| Install | |||
| 5 | Install fan into front lamp unit (E1, E2). | ||
| 6 | Connect electrical connector at fan. | ||
| 7 | Install corresponding cover (5, 6, 7, 8). | ||
| 8 | Install front lamp unit (E1, E2). | AR82.10-P-4733S |