Remove/Install Rear Outer Door Handle - AR72.12-P-2410MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 243, 247
MODIFICATION NOTES
| 19.07.2023 | Pull outer door handle (5) out of bearing bracket (6) toward rear, disconnect electrical connector (7) and remove door handle (5), added. | Operation step 4.1 |
Shown on model 177 on left side of vehicle
Shown on model 243 on left side of vehicle with code 889
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | Model 118, 177, 243, 247 with code 889 (KEYLESS-GO) with code 896 (Vehicle access and authorization via smartphone) |
|
| 2.1 | Remove stop plug (1). | Model 118, 177 | |
| 2.2 | Remove cover (3) of inner door edge. | Model 243, 247 | |
| 3 | Loosen screw (2). | ||
| 4.1 | Pull outer door handle (5) out of bearing bracket (6) toward rear, disconnect electrical connector (7) and remove door handle (5). | Model 243 with code 889 (KEYLESS-GO) |
|
| 4.2 | Pull door handle (5) up to end stop and remove cover (4). | Model 118, 177, 243, 247 except code 889 (KEYLESS-GO) If door handle (5) does not arrest, ↓ insert cover (4) with pulled door handle (5) and release door handle (5). Then repeat operation step. |
|
| 5 | Extend door handle (5) to the left or right out of the bearing bracket (6) and pull out toward the front. | ||
| 6 | Install in the reverse order. |