Remove/Install Plastic Welded Component Parts Of Door Trim - AR72.00-P-0001-01LW
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 166, 167, 172, 176, 177, 192, 205, 206, 213, 214, 217, 218, 222, 223, 232, 236, 238, 243, 246, 247, 253, 254, 257, 290, 292, 294, 295, 296, 297
Remove
- Drill the centering point of the plastic spot welds (1) with a drill bit.
Drilling process with high revolution speed and low operating speed.
Use a drill bit with a diameter of 3.5 mm.
- Cut off plastic spot welds with a spot facer (2).
Milling process with high revolution speed and low operating speed.
Use a M5 spot facer (2) as per DIN 373.
- Remove any remaining residues of the plastic spot welds (1) with the chisel (3).
Use a chisel (3) as per DIN 5139 with a blade width of 10 mm.
- Take off component.
Install
- Position component part.
- Cut off mounting domes (4) of the component part inserted in the door trim with the spot facer (2) so that it is flush with the level of the contact surface (5).
Only when installing a new component part.
- Fasten component part with washers (6) and screws (7).