Remove/Install Side Airbag Sensor - AR91.60-P-0710MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 243, 247
Shown on model 177 on left side of vehicle
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Detach ground line of on-board electrical system battery. | AR54.10-P-0003MFA | |
| 3 | Move front seat at left or right to foremost position. | ||
| 4 | Remove lower B-pillar trim. | AR68.30-P-4705MFA | |
| 5 | Release electrical connector (l) and disconnect. | ||
| 6 | Unscrew screw (2) and remove side airbag sensor (3). | ||
| *BA91.60-P-1010-01Q | |||
| 7 | Install in the reverse order. |
AIRBAG
| Number | Designation | Model 118 | Model 177 | |
|---|---|---|---|---|
| BA91.60-P-1010-01Q | Screw/bolt, frontal acceleration sensor to B-pillar | Nm | 8 | 8 |
AIRBAG
| Number | Designation | Model 243 | Model 247 | |
|---|---|---|---|---|
| BA91.60-P-1010-01Q | Screw/bolt, frontal acceleration sensor to B-pillar | Nm | 8 | 8 |