Remove/Install Starter - AR15.30-P-7100MFC

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Engine 260 in model 118, 177, 247

except code B01 (48V technology)

Fig 1: Starter Components Location - Model 118 With Engine 260 (Except Code B01)

Courtesy of MERCEDES-BENZ USA

	Risk of injury . Skin or eye injuries may result when handling hot or glowing objects.	Wear protective gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
	Risk of injury caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
Notice	Notes on avoiding damage through contamination and foreign objects		AH00.00-P-5000-01A
Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove air filter housing.		AR09.10-P-1150MFC
2	Remove battery carrier.		AR54.10-P-0028MFA
3	Release and disconnect electrical connector (1) at starter (M1).
4	Remove cover above nut (2).
5	Unscrew nut (2) and remove electric line for circuit 30 from starter (M1).	Nut, connection for terminal designation 30	*BA15.30-P-1001-01J
6	Remove screw/bolts (3).	Bolt, starter to crankcase/transmission	*BA15.30-P-1003-01J
7	Remove starter (M1).
	Check
8	Check pinion of starter (M1) for damage and wear.	If the starter (M1) is reused. If wear or damage is detected: ↓ Replace starter (M1).
9	Check ring gear on flywheel/drive plate for wear and damage.	Rotate engine at center Bolt, crankshaft in the direction of engine rotation. If wear or damage is detected: ↓ Replace flywheel/drive plate. Engine 260 in model 118, 177, 247 with transmission 724.1 except code B01 (48V technology)	AR03.30-P-8001MFI
		Engine 260 in model 118, 177, 247 with transmission 724.0 except code B01 (48V technology)	AR03.30-P-8001MFC
10	Install in the reverse order.

STARTER

Number	Designation		Engine 260
BA15.30-P-1001-01J	Nut, connection for terminal designation 30	Nm	16

STARTER

Number	Designation		Engine 260
BA15.30-P-1003-01J	Bolt, starter to crankcase/transmission	Nm	38