Remove/Install Tail Lamp Unit On Trunk Lid - AR82.10-P-4927MFV

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 118.3, 177.1/9

Fig 1: Tail Lamp Unit On Trunk Lid Components Location - Model 118.3 (Shown On Model 177.1)

Courtesy of MERCEDES-BENZ USA

Shown on model 177.1

	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Risk of injury caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Release trim of the trunk lid (1) until nut (2) is accessible.		AR68.30-P-8151MFV
2	Unbolt nut (2).
3	Remove inner rear left lamp unit (E3/1) or inner rear right lamp unit (E4/1) far enough until the electrical connector is accessible.	: Carefully position inner rear left lamp unit (E3/1) or inner rear right lamp unit (E4/1). Otherwise adjacent parts may be damaged. Do not crush or kink or subject lines to tension. This leads to line damage.
4	Release and disconnect electrical connector of inner rear left lamp unit (E3/1) or inner rear right lamp unit (E4/1).
5	Install in the reverse order.