Remove/Install Loudspeaker Amplifier Control Unit - AR82.62-P-7720MFC
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 247
as of model year 2022
with code 853 ("Midline" sound system)
Fig 1: Loudspeaker Amplifier Control Unit Components Location - Model 118 As Of Model Year 2022 With Code 853 (Shown On Model 177.0)
Shown on model 177.0
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off the ignition and keep the transmitter key outside the transmitter range (at minimum 2m). | ||
| 2 | Remove right rear seat of 3rd seat row. | Model 247.6 as of model year 2022 with code 847 (3rd seat row) with code 853 ("Midline" sound system) | AR91.12-P-0007MFX |
| 3 | Remove right trim in trunk. | Model 247.6 as of model year 2022 with code 853 ("Midline" sound system) | AR68.30-P-4801MFX |
| Model 118.3, 177.1/9 as of model year 2022 with code 853 ("Midline" sound system) | AR68.30-P-4800MFV | ||
| Model 118.6 as of model year 2022 with code 853 ("Midline" sound system) | AR68.30-P-4800MFD | ||
| Model 247.0/7 as of model year 2022 with code 853 ("Midline" sound system) | AR68.30-P-4800MFB | ||
| Model 177.0 as of model year 2022 with code 853 ("Midline" sound system) | AR68.30-P-4800MFA | ||
| 4 | Remove screw/bolts (2). | ||
| 5 | Remove nuts (3). | ||
| 6 | Unclip cover (1) on catch hooks (4) and remove. | ||
| 7 | Release and disconnect electrical connector (5). | ||
| 8 | Remove nuts (6) and remove sound system amplifier control unit (N40/3). | ||
| 9 | Install in the reverse order. | ||
| 10 | Commission sound system amplifier control unit (N40/3). | If sound system amplifier control unit (N40/3) is replaced. | |
| AD00.00-P-2000-06MFA |