Remove/Install Lens Hood On Windshield - AR67.10-P-2000MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 243, 247
Shown on windshield with a mono multifunction camera
Shown on windshield with a stereo multifunction camera
Shown on windshield of model 247.6 with stereo multifunction camera
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove | |||
| 1 | Remove multifunction camera. | Model 118, 177, 243, 247 | AR54.21-P-3000MFA |
| 2 | Release and disconnect electrical connector for lens hood (1). | ||
| 3 | Remove printed circuit board (2). | Model 243, 247.6 | |
| 4 | Remove lens hood (1). | Fig 1 | |
| Clean | |||
| 5 | Clean windshield in area of lens hood (1). | Do not apply cleaner to windshield. This may otherwise result in impairments. Cleaner |
*BR00.45-Z-1025-04A |
| Install | |||
| 6.1 | Install lens hood (1). | If the printed circuit board (2) is not present at electrical connector of lens hood (1). |
|
| 6.2 | Install lens hood (1). | If printed circuit board (2) is present at electrical connector of lens hood (1). | |
| 7 | Fasten printed circuit board (2) to carrier plate. | Model 243, 247.6 | |
| 8 | Connect electrical connector of lens hood (1). | ||
| 9 | Install multifunction camera. | Model 118, 177, 243, 247 | AR54.21-P-3000MFA |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1025-04A | Cleaner | A 005 989 19 71 |