Adjust Rear Door Triangular Window Height - AR67.30-P-0016-04MFC
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118.3/6
SIDE WINDOW(S)
| Number | Designation | Model 118 | ||
|---|---|---|---|---|
| BE67.30-P-1007-03E | Transition between upper edge of rear door/front door side window and upper edge of triangular window | Dimension "D" | mm | 0 (-1) |
SIDE WINDOW(S)
| Number | Designation | Model 118 | ||
|---|---|---|---|---|
| BE67.30-P-1008-03E | Transition between rear door/front door side window and trim element | Dimension "E" | mm | 8 (±1) |
Adjust rear door triangular window (1) in the z-direction, shown on model 118.3
- Remove the sealing rail (2).
- Remove covers (3).
- Release screw (4).
- Release nut (5) with the
socket wrench.
- Pull up rear door triangular window (1) and adjust dimension (d) to the rear door side window (6) with the
- Hold rear door triangular window (1) in this position and tighten screw (4).
Helper required.
Adjust rear door triangular window (1) in the y-direction, shown on model 118.3
- Close rear door.
- Open rear door side window (6).
- Move rear door triangular window (1) in Y-direction and adjust dimension (e) to trim element (7).
- Hold rear door triangular window (1) in this position and tighten the nuts (5) with the
Helper required.
- Open rear door.
- Check dimension (d) again.
If there is a problem,
↓
repeat adjustment procedure in the z-direction.
- Close rear door.
- Check dimension (e) again.
If there is a problem,
↓
repeat adjustment procedure in the y-direction.
- Install covers (3).
- Install the sealing rail (2).