Notes On Remove/Install Rear Window - AH67.20-P-2000-01T

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 117, 118, 156, 164, 166, 169, 170, 171, 176, 177, 190, 197.3, 202, 203, 204, 205, 207, 209, 210, 211.0/2, 212, 216.3, 217, 218, 219, 222, 230.4, 240, 242, 245.2, 246, 247, 292

Model 450.3/4, 451.3/4, 452.3/4, 454.0

The primer must flash off for at least 10 minutes.

Otherwise the adhesive effect of the adhesive material will be impaired.

The side window on the driver door must be open during the adhesive material's curing time.

Otherwise the rear-wall window may be pushed outward by the resulting air pressure when the doors are closed.

The rear-panel window must be positioned within a period of 10 minutes onto the body flange.

Otherwise the adhesive force of the glue starts to decrease.

The areas around the rear-wall window must be masked off with suitable duct tape.

Otherwise there is a risk of damaging the vehicle paintwork when cutting out.

Model 203.0/2

The silicon semi-conductors for ground connection are cut and they must be replaced when installing.

Use new retaining clips when installing water deflector.