Remove/Install Tire Pressure Monitoring Control Unit - AR40.15-P-0101MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 243, 247
with code 475 (Tire pressure monitor (TPM))
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Perform commissioning of tire pressure monitoring system control unit (N88). | If tire pressure monitoring system control unit (N88) is replaced. | |
| AD00.00-P-2000-06MFA | |||
| 2 | Remove underfloor paneling at left. | Model 118, 177, 247 with code 475 (Tire pressure monitor (TPM)) | AR61.30-P-1001MFA |
| Model 243 with code 475 (Tire pressure monitor (TPM)) | AR61.30-P-1001EQA | ||
| 3 | Release electrical connector (1) and disconnect. | ||
| 4 | Remove nuts (2) and remove tire pressure monitoring system control unit (N88). | Do not tighten the new nuts (2), press them on, only until they make contact. Otherwise, the nuts will be damaged (2). |
|
| 5 | Install in the reverse order. | ||
| Finishing activity | |||
| 6 | Reset tire pressure monitoring system using instrument cluster. | If tire pressure monitoring system control unit (N88) was replaced. |