LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2025 >> GLA250 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Wheels, Chassis Alignment -- 118 Chassis) >> Testing & Repair >> Carry Out Distance And Comparison Measurements On Front And Rear Axles - AR40.30-P-0402MFA

Carry Out Distance And Comparison Measurements On Front And Rear Axles - AR40.30-P-0402MFA

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 118, 177, 247 

DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
DANGER Risk of death  caused by vehicle slipping or toppling off during lifting Only lift vehicle at the lift support points specified by the vehicle manufacturer. AS00.00-Z-0032-01A
INSPECT Check     
1 Perform initial accident diagnosis.   AR60.00-P-1105MFA
2 Carry out clearance and comparative measurement on front axle and rear axle.    
REFER TO SPECIAL TOOLS 000 588 50 23 00 Body straightening system   WS60.00-P-0439K
    IMPORTANT These measurements determine whether it is necessary to replace chassis components or repair the body on the straightening bench.
If visible damage is found (e.g. crack formation, deformation) on the front axle carrier or rear axle carrier these parts must be replaced.
IMPORTANT A distance and comparative measurement on the front axle and rear axle using the "beam trammel" measurement method is not permissible.
 
3 Repair vehicle. Where damage has been detected.  
4 Perform wheel alignment measurement. If the vehicle has been repaired.  
      AR40.20-P-0200MFA