Separate And Connect Steering Coupling - AR46.10-P-8000-01MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177, 243, 247
STEERING SHAFT
| Number | Designation | Model 118 | Model 177 | |
|---|---|---|---|---|
| BA46.10-P-1001-01H | Clamp screw, steering coupling to rack-and-pinion steering | Nm | 28 | 28 |
STEERING SHAFT
| Number | Designation | Model 243 | Model 247 | |
|---|---|---|---|---|
| BA46.10-P-1001-01H | Clamp screw, steering coupling to rack-and-pinion steering | Nm | 28 | 28 |
Disconnect
- Turn rack-and-pinion steering into center position and fix steering wheel in place using
holding device.
- Remove retaining clip (1) and take out trim (2).
- Remove screw (3).
- Detach steering shaft (4) from steering gear (5).
Connecting
- Clean thread of steering shaft threaded connection (4) on steering gear (5).
If a microencapsulated bolt (3) was installed.
- Connect steering shaft (4) to steering gear (5).
- Tighten screw (3)
.
Replace the screw (3).
- Insert trim (2), plug in retaining clip (1) and press together.