Remove/Install Wind Deflector For Panoramic Sliding Sunroof - AR77.21-P-0101MFA
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model 118, 177
with code 413 (Panoramic sliding sunroof/glass roof)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Open panoramic sliding sunroof completely. | ||
| 2 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 3 | Unscrew bolts (2). | ||
| 4 | Unclip wind deflector (1) from guide rails. | ||
| 5 | Set up wind deflector (1) such that it points vertically upward. | When replacing, press the springs of the wind deflector (1) forward to position the springs in their working area. The springs and wind deflector (1) will otherwise be damaged. |
|
| 6 | Push the wind deflector (1) forward in front of the bearing pin (3) and remove the wind deflector (1). | ||
| 7 | Install in the reverse order. |