General Notes On Working On Vehicles With Level Control/ADS - AH32.00-P-0002-01A
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Model All
with CODE (216b) Self-levelling suspension all-around, with adaptive damping system (ADS)
with CODE (216c) Adaptive damping system (ADS II) with electronic level control
with CODE (217a) Self-levelling suspension on rear axle with ADS with CODE (480) Level control system at rear
Courtesy of MERCEDES-BENZ USA
The following instructions should be followed when disconnecting and connecting pressure lines:
Clean contaminated line connections before disconnecting them. Seal disconnected lines and hoses and connections to components immediately with blind plugs.
Only use open box wrench and special tool when loosening and tightening pressure lines to avoid damage to the line connections.
Check the component concerned and line connections for leaks after assembly work on the suspension system.