Apply Adhesive Material For Front Fixed Element Of Panoramic Sliding Sunroof - AR77.21-P-0803-04MFB
Model 243, 247
with code 413 (Panoramic sliding sunroof/glass roof)
| 000 588 02 72 00 Sealing and corrosion protection gun | WS97.00-P-0003B |
Bonding surfaces must be free from dust, oil, grease, wax, dirt residues and other adhesive components.
Otherwise, there may be adhesion problems.
Only use the repair kit specified in the XENTRY Portal parts information.
- Open adhesive cartridge and insert sealing and corrosion protection gun.
To press out remaining residual quantities in adhesive cartridges, insert adapters
in adhesive cartridges and plates at push rods of sealing and corrosion protection gun.
- Cut application nozzle so that the adhesive bead can be applied with a height of 14 mm and a width of 8 to 10 mm.
The height of adhesive bead must be 3 mm when installed.
- Install application nozzle on adhesive cartridge.
- Fabricate reference adhesive bead.
The reference adhesive bead is used to check and confirm the adhesive curing of the adhesively bonded connection before moving the vehicle for the first time after gluing in the front fixed element.
- Apply adhesive material evenly on the bonding surfaces on the panoramic sliding sunroof frame.
Apply adhesive material within 25 minutes and position front stationary element and fix in place on the panoramic sliding sunroof frame within no more than a further 15 min.
Otherwise the strength of the adhesive connection can be impaired and proper adhesion of the adhesive material is not ensured.
Apply adhesive material in the form of an adhesive bead with a height of approx. 14 mm and a width of approx. 8 to 10 mm.
Immediately remove soiling caused by adhesive.