Torque Specifications
WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Center support fluid feed bolts | 32 | 24 | - |
| Coast clutch hub-to-overdrive carrier boltsa | - | - | - |
| Extension housing-to-case bolt | 47 | 35 | - |
| Flexplate inspection cover bolts | 34 | 25 | - |
| Fuel line bracket nut | 12 | 9 | - |
| Line pressure tap plug | 12 | 9 | - |
| Manual valve detent lever shaft retaining pin | 10 | - | 89 |
| Output shaft flange bolt | 130 | 96 | - |
| Output shaft retaining nut | 200 | 148 | - |
| Output shaft speed (OSS) sensor bolt | 9 | - | 80 |
| Overdrive (OD) piston return spring bolts | 29 | 21 | - |
| Parking pawl abutment-to-case bolts | 25 | 18 | - |
| Parking rod guide plate-to-case bolts | 25 | 18 | - |
| Power take off plate-to-case bolts (if equipped) | 41 | 30 | - |
| Pump body-to-case bolts | 27 | 20 | - |
| Pump-to-pump body bolts | 31 | 23 | - |
| Remote filter bracket bolts | 35 | 26 | - |
| Remote filter fluid cooler tube nut fitting | 40 | 30 | - |
| Remote filter-to-bracket bolt | 11 | 8 | - |
| Selector lever cable bracket bolts | 48 | 35 | - |
| Solenoid body and backing plate-to-case boltsa | - | - | - |
| Solenoid body electrical connector bolt | 5 | - | 44 |
| Steering damper-to-frame bolt | 103 | 76 | - |
| Torque converter-to-flexplate nut | 48 | 35 | - |
| Transmission control module (TCM) bracket-to-frame bolts | 48 | 35 | - |
| TCM-to-bracket bolts | 8 | - | 71 |
| Transmission fluid filler tube nut | 10 | - | 89 |
| Transmission fluid cooler tube nut case fitting | 51 | 38 | - |
| Transmission fluid cooler tube nut-to-case fitting | 40 | 30 | - |
| Transmission fluid pan drain plug | 18 | 13 | - |
| Transmission fluid pan-to-case bolts | 15 | 11 | - |
| Transmission insulator studs | 75 | 55 | - |
| Transmission insulator-to-crossmember nuts | 115 | 85 | - |
| Transmission insulator-to-extension housing bolts | 103 | 76 | - |
| Transmission range (TR) position sensor-to-case bolts | 10 | - | 89 |
| Transmission support crossmember-to-frame bolts and nuts | 81 | 60 | - |
| Transmission-to-engine bolts | 47 | 35 | - |
| Turbine shaft speed (TSS) and intermediate shaft speed sensor bolt | 9 | - | 80 |
a Specific tightening sequence is required. See the procedure.