LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2024 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 3385 (Automatic Transmission - 5R110W - F250-F550 Super Duty - Specifications, Description And Operation, Diagnostic Tests, Diagnostic Trouble Code (DTC) Charts) >> Diagnostic Tests >> Transmission Drive Cycle Test >> Before Pinpoint Tests

Before Pinpoint Tests

WARNING: This page is about a different car, the 2008 Ford Pickup, 2008 Ford F550 Super Duty, 2008 Ford F450 Super Duty, and 2008 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Prior to entering pinpoint tests, check the PCM wiring harness for correct connections, bent or broken pins, corrosion, loose wires, correct routing, correct seals and their condition. Check the PCM, sensors and actuators for damage. Refer to the INTRODUCTION - GASOLINE ENGINES article or INTRODUCTION - 6.4L DIESEL ENGINES article.
NOTE: If a concern still exists after electrical diagnosis has been carried out, refer to Diagnosis By Symptom .

If DTCs appear while carrying out the On-Board Diagnostic (OBD), refer to the Diagnostic Trouble Code Chart for the appropriate procedure. Prior to entering pinpoint tests, refer to any TSBs for transmission concerns.

scientia non olet · About LEMON Manuals