LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2024 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2768 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Knuckle >> Installation

Wheel Knuckle: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The axle bores and adjustment sleeve contact areas should be clean, allowing for the adjustment sleeve to be correctly drawn in and the ball joint to correctly seat into place. If not clean, damage to the ball joint, adjustment sleeve or axle bores can occur.
  1. Thoroughly clean the axle bore and adjustment sleeve contact areas.
  2. Install the camber adjustment sleeve.
  3. Position the wheel knuckle onto the axle and install the nut onto the upper ball joint. Do not tighten the nut at this time.
  4. Apply threadlock and sealer to the threads of the lower ball joint and install the new nut onto the lower ball joint. Do not tighten the nut at this time.
  5. Tighten the lower ball joint nut to 59 Nm (44 lb-ft).
    6. NOTE: Do not loosen the nut to install the cotter pin.
  6. Tighten the upper ball joint nut to 94 Nm (69 lb-ft) and install the cotter pin.
    • If necessary, tighten the nut until the cotter pin can be installed.
  7. Tighten the lower ball joint nut to 204 Nm (150 lb-ft).
  8. Connect the tie-rod end to the wheel knuckle and install the nut and a new cotter pin.
    • Tighten to 115 Nm (85 lb-ft). If necessary, tighten the nut until the cotter pin can be installed.
  9. Install the new main seal onto the axle shaft.
    1. Position the main seal onto the axle shaft.
    2. Using the Drive Pinion Oil Seal Installer/Remover and Wheel Knuckle Seal Installer, seat the main seal onto the axle shaft.
      Fig 1: Installing Main Seal Onto Axle Shaft
      G06776400Courtesy of FORD MOTOR CO.
    10. NOTE: The knuckle bore must be clean enough to allow the Drive Pinion Oil Seal Installer/Remover to seat completely by hand. Do not press or draw the wheel knuckle seal and axle shaft into place or damage to the seal may occur.
    NOTE: Do not apply any lubricant to the surface of the wheel knuckle bore.
  10. Position the axle shaft and main seal in to the wheel knuckle and axle housing.
    11. NOTE: F-450/F-550 shown in illustration, F-250/F-350 similar.
    Fig 2: Locating Snap Ring
    G06776401Courtesy of FORD MOTOR CO.
  11. Position the Wheel Knuckle Seal Installer onto the axle shaft and install the snap ring.
    12. NOTE: F-450/F-550 shown in illustration, F-250/F-350 similar.
    Fig 3: Installing Wheel Knuckle Seal And Axle Shaft
    G06776402Courtesy of FORD MOTOR CO.
  12. Using the Drive Pinion Oil Seal Installer/Remover and Wheel Knuckle Seal Installer, install the wheel knuckle seal and axle shaft.
  13. Install the wheel bearing and wheel hub. For additional information, refer to WHEEL BEARING AND WHEEL HUB .
  14. If equipped, connect the pulse vacuum hub hose.
scientia non olet · About LEMON Manuals