LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2024 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2750 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Removal

Output Shaft Speed (OSS) Sensor: Removal

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the Output Shaft Speed (OSS) sensor connector.
    Fig 1: Locating Output Shaft Speed (OSS) Sensor Connector
    G06140648Courtesy of FORD MOTOR CO.

    Transmissions with a fixed flange 

    3. NOTE: Prior to removing the sensor, make sure that the area around the sensor is free of foreign material to prevent contamination entering the transmission.
  3. Remove the OSS  sensor.
    1. Remove the bolt.
    2. Remove the OSS  sensor.
      Fig 2: Identifying OSS Sensor And Bolt
      G06140649Courtesy of FORD MOTOR CO.

    Transmissions without a fixed flange 

    4. NOTE: Prior to removing the sensor, make sure that the area around the sensor is free of foreign material to prevent contamination entering the transmission.
  4. Remove the OSS  sensor.
    1. Remove the bolt.
    2. Remove the OSS  sensor.
      Fig 3: Identifying OSS Sensor And Bolt
      G06775731Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals